(redirected from Insertion loss)
Also found in: Encyclopedia, Wikipedia.
Category filter:
ILIllinois (US postal abbreviation)
ILIsrael (top level domain)
ILIndependent Living
ILInternational League (AAA minor league)
ILInternational Law
ILIndex List
ILInformation Literacy (research instruction)
ILIntermediate Language
ILIgnore List
ILIntermediate Level
ILIntegrated Logistics
ILInsertion Loss
ILInterleukin (cytokine)
ILIntegrated Learning
ILIlyushin (Russian aircraft designer)
ILIntegrity Level
ILIndicator Light
ILIonic Liquid
ILIdrettslag (Norwegian: Sports Club)
ILInternational Logistics
ILInner Loop (Beltway)
ILItalian Lira
ILIndependent Laboratory
ILIntermediate Location (US DoD)
ILInstallation Location
ILInfralimbic Cortex (brain)
ILInside Linebacker (football)
ILInterference Lithography
ILInstruction List
ILInjured List
ILInstructional Leader
ILIron Loss
ILIndirect Labor
ILInteraction Level
ILIdentification List
ILInstructional Literature
ILIsthmian League (British Soccer League)
ILInvert Level (civil engineering)
ILInstallation and Logistics
ILIntact Loop
ILInvestigatory Leave
ILIgnitor Light
ILIn-rush Limiter
ILImmersible Light
Copyright 1988-2018, All rights reserved.
References in periodicals archive ?
The terms insertion loss, transmission loss, noise reduction, and attenuation are often used interchangeably for HVAC duct systems.
Whenever a component such as a connector is inserted into the signal path between source and destination, it causes a degradation of the signal: insertion loss, expressed in dB, is a measure of this degradation.
Another critical component of EMI filter design is minimizing insertion loss to ensure maximum efficacy.
These factors include: the number of lines that need filtering, design requirements for MRI-compatible devices, insertion loss capabilities, battery life, and cost.
CITATION: Zhang, Y., Herrin, D., Wu, T., and Hua, X., "Determination of Transmission and Insertion Loss for the General Multi-Inlet Multi-Outlet Case," SAE Int.
Speeding Edge 16-layer TV: Tachyon had an insertion loss of 0.849 dB/in.
Insertion loss is not necessarily easier to predict using mathematical or computational approaches because source and termination impedances may in fact vary across the duct cross-section.
Basically, a higher dielectric loss will cause higher circuit insertion loss, although that depends on the circuit thickness and the effects of conductor loss.
The multimode interpolation return loss measuring instrument is specially used in the optical fiber cable and other fiber optic passive devices, optical active device and optical fiber communication system of insertion loss and return loss test.
He noted the unit achieves lower insertion losses as the Thermally Stabilized Plasma operates in a partial vacuum to produce a wider heat profile.
First of all, the insertion loss of (4 * 2.4 * 0.63) m concrete wall will be given.