411

(redirected from Length Required)
AcronymDefinition
411Local Telephone Information (United States)
411Length Required (HTTP status code)
Copyright 1988-2018 AcronymFinder.com, All rights reserved.
References in periodicals archive ?
"I'm really pleased to have donated 16 inches, which is more than double the minimum length required.
* Use two or more shorter sections of flex and connect them to get the final length required. There are many ways of making the connections.
In this process, the grader must make the grading decision with a combination rule that includes scaling diameter, log length, minimum length of clear cuttings, the maximum number of clear cuttings allowed, and the minimum proportion of log length required in clear cuttings.
Always knew that I can adapt to the shorter format and bowl the line and length required to succeed," he revealed.
Since the channel area is naturally the ratio of the square of the diameters when changing screw size, if the flight pitch and flight width are kept proportional, the increase in melting length required becomes largely proportional to the increase in depth of the metering section or (D2/D1)[degrees]-7.
But the fact was that the crew failed to see the airport where they were supposed to land and instead came down at a small airfield whose short runway was barely half the length required for a 707.
The main hooping challenge with this bodice type is always the front, because of the length required to fit the bust.
(1) For the calculation model in this paper, hydraulic fracturing will not occur without the permeable weak surface (initial crack), and the critical initial crack length required for hydraulic fracturing is 5.3 m.
MURRELEKTRONIK says its new brochure--Preassembled Power Connectors--features power connectors designed to make connecting motors easy, even small quantities are available and the connectors come in many variants with cables that are precisely cut to the length required. The company says the M12 Power is a high performing M12 connector, it is a reliable solution for to linear drives, stepper motors as well as power supply lines for field bus modules and it is a compact alternative to 7/8in connectors in applications that require high power density.
The pre-chlorinated pipe bursting begins on the surface by fusing sections of HDPE pipe to the full length required to complete a run.