LW

(redirected from Line Width)
Also found in: Dictionary, Wikipedia.
Category filter:
AcronymDefinition
LWLeft Wing
LWLightwave (NewTek)
LWLight Weight
LWLimewire (p2p software)
LWLuftwaffe (German: air force)
LWLong Wave (see LF)
LWLow Water
LWLimited Warranty
LWLeatherworking (game)
LWLeeWay
LWLetter Writer
LWLethal Weapon (movie)
LWLaser Warning (US Air Force)
LWLaunch Window (space flight)
LWLine Width
LWLand Warrior (Army)
LWLock Washer
LWLangwelle (radio band 30-300 KHz, German)
LWLutheran Worship
LWLast Wish
LWLandsteiner-Wiener (blood group)
LWLord Willing
LWLaser Weapon
LWLower West
LWLow-Warning
LWLeave Word (trunks)
LWLylat Wars (game)
LWLiving Worlds
LWLeaky Wave
LWLeft Waist Gunner
LWLoodswezen (Dutch)
LWUS East Coast to Southwest Pacific (routing designation;US Navy)
LWLincoln Way High School
LWLiegewagen (German Couchette)
LWLAN War (gaming)
LWLouisville and Wadley Railway Company
LWLincoln-West High School (Ohio)
LWLAN/WAN Exchange
Copyright 1988-2018 AcronymFinder.com, All rights reserved.
References in periodicals archive ?
The line width tool is clicked to select a desired thickness for lines or object outlines.
To avoid this problem, we propose to increase bandwidth softening antenna corners, making it less dependent on frequency [3, 4]; to set those changes we selected the best parameters of the analysis, that is, strip line width a = 2.0 mm, substrate thickness h = [lambda]/11, and open circuit load; antenna modification is shown in Figure 10.
The template patterns with broader line width generate the accumulation of the polymer film in A direction more easily.
The line widths of amorphous phase and interphase in nanocomposites are both higher than those of polyethylene bulk.
(4) This procedure restricts the physical filter topolo to one where line widths and impedances are the same, while the gaps are allowed to vary, as shown in the equivalent circuit of Figure 2.
Even the modest decreases in minimum line width permitted by pushing current optical lithography to its limit could enable chip designers to put both memory and logic circuits on the same chip.
Suggestions for Reducing Crosstalk DESIGN FEATURE DIRECTION FOR BETTER OR WORSE Aggressor TX and victim RX Asynchronous generally worse synchronous or asynchronous Channel-to-channel spacing Larger is better FEXT: microstrip or stripline Stripline is better NEXT: microstrip or stripline Stripline is better for channel to channel spacing >2x line width Differential impedance Lower impedance is generally better Interleaved or non-interleaved Microstrip: best is interleaved Stripline: best is non-interleaved Line to line coupling Tighter is always better.
This database features not only wavelengths but also ionization level, line width, limit of detection and dynamic range of each line, providing data that allows the combination of single-element spectra to mimic real-life samples.
Let's start with a simple microstrip with a line width of 10 mils, dielectric constant of 4.5 and thin metallization.
The most common technique to assess magnetization damping in magnetic films is to measure the ferromagnetic resonance line width of the material.
In this circuit it is assumed that the feed and coupled lines are of the same impedance [Z.sub.o] (that is, of the same width W), the slot width W is identical to that of the feed line width and the dielectric constants [[epsilon].sub.r] of the feed line and coupled line substrates are the same.