Also found in: Encyclopedia.
MOHMMedal of Honor Museum (Chattanooga, TN)
References in periodicals archive ?
Transphorm's first 900 V device, the TP90H180PS, with a typical on-resistance of 170 mOhm in a TO-220 package is JEDEC qualified and has been available through Digi-Key since 2017.
For the given data the discharge circuit inductance was equal to 2.398 [micro]H, and the calculated active resistance of the discharge circuit was equal to R = 200 mOhm. Circuit parameters were measured in the same way, when different banks were used (Table 2).
Eleven variables were collected: temperature, pH, pHmV, Redox Potencial (ORP), Dissolved Oxygen (DO ppm and saturation), conductivity ([mu]_S, [mu]_SCM, Mohm, Total Dissolved Solids (TDS) and Salinity.The parameters adopted as reference in this investigation are considered as basic descriptive variables of aquatic metabolism, being related to characteristics such as acidity, presence of dissolved salts and oxygenation (TUNDISI & TUNDISI, 2008).
With each modules' overall height at 1.5mm, the connection is flat but can be loaded up to 5A at 10 mOhm. Because the welding between each wire and plug is powerful, maximum resistance is not impaired.
Parameters FR4_epoxy Rogers RT/ duroid 5870 Dielectric constant 4.6 2.33 Loss tangent 0.02 0.0012 Water absorption (%) <0.25 0.02 Tensile strength <310 MPa 450 MPa Volume resistivity (Mohm x cm) 8 x [10.sup.7] 2 x [10.sup.7] Surface resistivity (Mohm) 2 x [10.sup.5] 3 x [10.sup.7] Breakdown voltage (kV) 55 >60 Peel strength (N/mm) 9 5.5 Parameters Taconic Neltec NY Dielectric constant 2.4 2.4 Loss tangent 0.0016 0.0016 Water absorption (%) <0.02 <0.02 Tensile strength -- -- Volume resistivity (Mohm x cm) 1 x [10.sup.7] 1 x [10.sup.7] Surface resistivity (Mohm) 1 x [10.sup.7] 1 x [10.sup.7] Breakdown voltage (kV) -- >60 Peel strength (N/mm) 12 12 * All information collected from the data sheet.
"At KET we had originally planned to develop the parts using nylon PA66 because of its good mechanical properties, but PA66 could not meet the OEMs electrical resistance requirements under high temperature testing conditions"--minimum 500 MOhm at 120[degrees]C and DC 500V).
The Clinical Practice Guidelines (CPG) for Management of Dementia developed by the Ministry of Health Malaysia (MOHM) were launched in 2010.
The dielectric constant of the material is [[epsilon].sub.r] = 9.2, the dissipation factor tan [delta] = 0.0022, thermal coefficient is -38ppm/K, Volume resistivity is 2 x [10.sup.8] Mohm-cm, surface resistivity is 4 x [10.sup.7] Mohm and the density is 2.8gm/[cm.sup.3].
The sEMG signals were amplified by using a multi-channel, isolated biomedical signal amplifier BM623 (Biomedica Magoni) with an input impedance >10 MOhm and CMRR >100 dB.