References in periodicals archive ?
The broader expansion peaks observed for the PP-MMT materials, also previously observed when comparing PP1.
Four PP1 Pixel Pipe Processors, each containing 290,000 gates, render pixels into a Rambus DRAM frame buffer.
Influence of Temperature, Stress, and UV Light on the Creep Behavior of PP1
Similar to the PP1 composites, at the condition of same filler content, the yield strength, the flexural strength, and modulus of the PP2/CC25/CC0.
For PP1 all curves of the transient elongational viscosity superimpose on the linear viscoelastic curve, which corresponds very well with the threefold value of the linear start-up viscosity 3 [[eta].
Figure 2 shows the TEM images, where the dark areas represent the clay particles and grey areas represent the continuous PP matrix, for PPCN prepared with PP1 and PP2.
A better dispersion of the OMMT is observed for the blend with PP1 as the continuous phase because of its higher viscosity than that of PP2.
PP1 shows the highest steady shear viscosity among four polymers under the shear rates ranging from [10.
Blends of 10, 25 and 50 wt% of branched PP2 and PP3 in linear PP1 polymer were produced with the twin-screw extruder using a compounding screw configuration.
Figure 2 shows WAXD patterns of samples of PP1 and PP3 prepared by method 2 and crystallized at 135[degrees]C.
7, clear differences were observed between the cell morphologies of PP1 and PP2.
Numerical simulation was performed for PE1, PE2, PP1 and LDPE1 materials.
Acronyms browser ?
Full browser ?
- PP cell
- Pp chain
- Pp i
- pp junction
- PP reaction